Introduction
This prerequisite guide provides steps for removing the speaker housing, which is key in opening the device for further replacement procedures.
-
-
Locate the battery housing on the back of the flashlight as pictured.
-
Unscrew the single 8 mm Phillips #1 screw.
-
Lift the battery housing cover to reveal the battery terminals. Remove the batteries.
-
-
-
Locate the light blue speaker housing on the bottom of the flashlight.
-
Remove the three 6 mm Phillips #0 screws.
-
Once the screws have been removed, pull the housing away from the yellow body of the flashlight. Be careful not to disconnect the white wires from the speaker, unless speaker replacement is required.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
