Introduction

Do not blow air into tube!

  1. 3xuNQIhuXs2XUDwB
    • Remove the four rubber feet of the device using a metal spudger.

  2. 1ei14ULmbwWVfTiO
    1ei14ULmbwWVfTiO
    utorX5oROpEptkcn
    • Remove the four 9 mm Phillips #0 screws located under the feet of the device.

    • Remove the four 9 mm Torx #8 screws located on each side of the bottom the device.

  3. vsJ1XXupavPuJIFr
    vsJ1XXupavPuJIFr
    pOD5MwkMGkJrFVsu
    • Pull the bottom cover of the device towards you.

  4. HbXjAUjt2SDoCDup
    HbXjAUjt2SDoCDup
    rOsORsOrMEt4Cxsv
    • Remove the four 13 mm Phillips #1 screws.

  5. aiQA3cHgBSHTNOJc
    aiQA3cHgBSHTNOJc
    rMwpc26rsDZsZVpk
    • Use one hand to grip the device from the side of the handle, and use the other hand to grip the side of the device that contains the woofer

    • The woofer is the circular component located at the bottom of the device after the bottom cover has been removed

    • Pull apart the compartments by applying force in opposite directions.

    • Do not pull with extreme force!! There are many electrical wires inside the device that can become damaged if the bottom panel is removed without care

  6. CdfTOgkcIr5Tu5Ug
    • Disconnect the seven cables attached to the motherboard.

    • Do not use too much force when pulling on the wires. Pulling with too much force can damage the wires.

  7. qtsoBoGlOZgNWnG5
    • Remove the four 8 mm Phillips #1 screws.

  8. XHJTq4hWQ2En1Zh4
    XHJTq4hWQ2En1Zh4
    egQrlmLoMObOgAoe
    DYNieHqq5seeeB4w
    • place your hands on each side of the air vent and then place your index finger on the thin plastic half circle that holds the vent in place.

    • Pull the plastic half circle towards you.

    • Put both of your hands inside the tube as shown and push away from you.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Helen Huynh

Member since: 14/09/15

338 Reputation

One comment

Where can I get a new motherboard?

american1gigolo -