Shark Rotator NV502 HEPA Filter Replacement

Written By: Samuel
  • Comments: 2
Shark Rotator NV502 HEPA Filter Replacement

Difficulty

Easy

Steps

2

Time Required

2 minutes

Introduction

When the vacuum starts losing suction, the HEPA filter should be checked and cleaned. Dirt in the HEPA filter causes resistance to the suction of the vacuum so the filter should be checked on a regular basis. If cleaning it did not help, replace the HEPA filter with a new one.

  1. KmTfYQNVwVmGUwmg
    KmTfYQNVwVmGUwmg
    fBSLKq2UmECsp3av
    FrnYatByx2IIZFZM

    • Orient the vacuum facing you and locate the tab on the left side of the vacuum, next to the arrow labeled ‘HEPA Filter’.

    • Pull on the tab to remove the filter cover.

  2. CrTciDCCBrKMAaoE

    • Pull the HEPA filter out.

    • Clean or replace the filter.

    Well this is a totally incomplete instruction.

    HOW do you clean the HEPA filter?

    ILLYANA ENNETT -

    In the previous page it says to just run cold water through it until the water looks clear. (Don't use any soap) Then let dry for 24 hours before reinstalling.

    Natalie Morse -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Samuel

Member since: 06/10/16

307 Reputation

0 comments